tile restoration – Tiling Tips – Tips and Information About Tiling

Multiple Marble Wall And Floor Tiles Cleaned

27th March 2017 Reese Mackie 0 Comments cleaning services, cloakroom, East Surrey, kitchen, marble mosaic, marble tile, Sealing, shower cubicle, Tile Cleaning, tile restoration, Woking

This job was to refresh the Marble tile installed in a house in Woking. There were a number of different marble tiles installed on the wall and floor including two shower cubicles, a bathroom floor, a small cloakroom floor and the kitchen floor; the pictures below show before and after photographs for each job. Cleaning a Marble Tile Shower Cubicle I started with the shower cubicles using Tile Doctor Oxy-Pro which is a specific product for cleaning showers and comes with a spray attachment that mixes the cleaning agent with air making it lighter and helping it stick to vertical surfaces. This was left to dwell on the surface for a while and then the tiles were scrubbed before being rinsed down. This action not only cleaned the dirt and soap scum off the tile it also got rid of some mould that had started to grow. In one shower there was a build-up of limescale on the wall so to get rid of this I used a little Tile Doctor Grout Clean-up, this product is usually for removing grout smears from tile however it’s also good at removing most types of mineral deposits such as Limescale, you do have to be quick though as it’s an Acid based product I had to be quick and to thoroughly rinse because I didn’t want to damage the marble. Marble Mosaic Bathroom floor tile cleaning The next

Marble Posts

Dealing with Scratched Marble Floor Tiles

24th March 2017 Reese Mackie 0 Comments cleaning services, floor restoration, hallway, kitchen, Lincolnshire, marble tiles, natural riven stone, re-sealing, Tile Cleaning, tile restoration, tiled floor, Woodhall spa

This Marble Tiled floor was installed in the conservatory of a house in Woodhall Spa who had asked if we could remove the scratches from their inherited marble tiles around the door area and where furniture had been dragged across the tile as shown in the photos. Interestingly our customer is a chief engineer on cruise ships all over the world and knew what this floor could look like if restored professionally. Burnishing Mable Tiles Other than the scratches the majority of the floor had been well maintained so the solution was to burnishing the marble back to its original condition using a set of diamond encrusted pads fitted to a slow speed machine and lubricated with a little water. The burnishing pads come in a set of four and applied to the floor with a little water one by one using a rotary machine running at slow speed. The process starts with the coarse pad which strips back the top layer and removes sealers and dirt from the surface of the stone. The pads then become finer and finer with the last pad being a final polish that takes the tile back to near it’s originally intended shine. You can see from the photographs that we actually managed to resurface the marble, remove the scratches and we also filled in some small holes and then allowed the floor to dry

Marble Posts

Commerical Marble Tiled Floor Restoration

20th March 2017 Reese Mackie 0 Comments classic marble floor, cleaning services, Hampshire, marble tile cleaning, marble tiles, Sealing, Tile Cleaning, tile restoration, tiled floor, winchester

Photographs below of a classic black and white Marble floor tile installation at premises in the city of Winchester. As you can see these Marble tiles had seen some traffic and were not in the best of condition following on from some building work that had been going on; fortunately we are quite used to dealing with these problem and have just the right products and equipment to restore them. Marble Tile Cleaning and Polishing For best results on hard stone surfaces such as Marble we burnish the floor using a set of diamond encrusted polishing pads. You start with a coarse pad which applied with a little water to remove surface dirt and sealers etc. before moving through a set of finer polishing pads until you reach a high shine glossy finish. Half way through the burnishing process we stopped to apply a dilution of Tile Doctor Pro-Clean along the grout lines and give them a scrub with stiff hand brushes repeating the process in stubborn areas. After the treatment the floor was washed do to remove any soiled solution before being buffed with a white buffing pad. Any trace of its previous condition was now gone and the floor was uniform in appearance, it took much of the day to do the polishing and a set of four burnishing pads to acquire the right lustre. Source: Mabrle

Marble Posts

Polishing Tumbled Marble

17th March 2017 Reese Mackie 0 Comments cleaning services, Dewlish, Dorchester, Dorset, floor maintenance, marble tiles, sealing tiles, Tile Cleaning, tile restoration, tiled floor, tumbled marble floor

This 50m2 Tumbled Marble tiled floor in Dewlish, near Dorchester had not been deep cleaned and re-sealed for at least five years and showed signs of the normal wear and tear associated with a busy kitchen/dining room and a dog that enjoyed muddy walks. The old sealer was now breaking down allowing dirt to become ingrained in the Marble making it difficult to clean. Stripping a Tumbled Marble Floor To restore the surface finish it needed to be burnished using a set of diamond encrusted burnishing pads. The pads come in a number of different grades from coarse (used to strip off sealers and dirt from the Marble) too very fine (used for final polishing) and are applied one after another starting with the coarse pad and moving through to the very fine pad towards the end. Each stage requires a little water which captures the soil and is rinsed away and removed with a wet vacuum. This process completely removed the old sealer and surfaces scratches with a new shine. The floor was given a thorough wash down at this point again using a wet vacuum to remove as much water as possible from the surface before leaving it to dry for the evening. Sealing Tumbled-Marble Tiles The next day the Marble had dried and I started to seal the tiles using two coats of Tile Doctor Colour Grow sealer

Marble Posts

Removating old Marble Flagstones in West-Sussex

10th March 2017 Reese Mackie 0 Comments cleaning services, damaged marble tiles, marble tiles en-suite, shower cubicle, Tile Cleaning, tile maintenance, tile restoration, tiled shower room, west sussex, Woodmancote

Apologies in advance but I’m going to start this post with a warning; there are some very strong cleaning products available in supermarkets and most of which are completely unsuitable for use on natural stone floors because they contain acid. Even weak acids used over time will erode and reduce the life of a sealer and can lead to small holes appearing in your tiles so you do need to be careful what you apply and always read the label. The reason I mention this is I recently had a client in the village of Woodmancote with a Marble Tiled En-Suite who had sent over some photographs showing how the tiles had become marked after using Cilit Bang to clean them. Cilit Bang is a very strong product and has a great reputation for tackling tricky cleaning problems however it contains Benzenesulfonic Acid so it should not to be used on Stone. If you check the literature it does not say it can be used on stone although it does mention the product can be used on tiles and I suspect this is where the confusion comes from as I suspect it should say ceramic tiles. Getting back to the story I informed the client that it was tricky to tell from the photographs what would be required so I offered to pop round when next in the area and take a look. We offer a free no obligation home-survey

Marble Posts

Repairing Damaged Marble Shower Tiles

9th March 2017 Reese Mackie 0 Comments cleaning services, damage marble tiles, east sussex, restoring marble tiles, ringmer, shower room cleaning, Tile Cleaning, tile maintenance, tile restoration, tiled shower room

We were recently received a referral from a well-known house cleaning company who needed some assistance to resolve an issue with a Marble Tiled Shower at a Georgian property in Ringmer. Unfortunately one of their staff had sprayed a Cillit Bang cleaning fluid onto the tiles to remove Limescale deposits and had marked the tiles with white streaks which could not be removed. Now Cilit Bang is a very strong product and although it has a reputation for tackling tricky cleaning problems it contains Benzenesulfonic Acid which like any acid should not be used on Stone as it will damage it. If you check the internet you will find this problem is not uncommon and numerous people have experienced the same issue, the good news is there is a solution. Polishing Damaged Marble Shower Tiles Using a spray bottle containing a dilution of Tile Doctor Pro-Clean and a set of small Diamond encrusted burnishing pads attached to a handheld buffer I went to work on the tiles stripping away the existing sealer and bringing back the surface of the stone. During this process the damage to the tiles started to fade and once the sealer was removed the tiles took on a washed out appearance which was to be expected at this stage. Sealing Marble Shower Tiles After drying any wetness with a heat gun I left