hallway – Tiling Tips – Tips and Information About Tiling

Polishing a Small Marble Lobby at an Edinburgh Residence

23rd September 2017 Reese Mackie 0 Comments cleaned, Edinburgh, entrance, hall, hallway, high shine, lobby, Lothian, Marble, polished, sealed, tiled, vestibule

I was asked to take a look at this small but beautiful Marble tiled vestibule at the entrance to a lovely house in Edinburgh. As you can see from the photograph below the colours in the Marble were looking washed out and the overall appearance was dull and lifeless. As the main entrance it must have seen a lot of foot traffic and a fair amount of wear and abuse over the years. Cleaning and Polishing Marble Tiles The first task was to brush and vacuum the floor to remove debris and grit. After this the floor was sprayed with a dilution of Tile Doctor Pro-Clean a tile cleaner that is safe to use on stone floors and scrubbed in with a black buffing pad fitted to a rotary machine. This released a lot of dirt from the tile and the soiled cleaning solution was then rinsed off with water and extracted using a wet vacuum. Once the floor had all the surface dirt removed we then proceeded to polish the marble with a set of diamond burnishing pads which restore the shine the stone. The burnishing pads come in a set of four and you start with a coarse pad with a little water and work your way through the set moving from a the coarse pads through to the finer pads; this process polishes the stone more and more until you get a smooth finish. After each pad was used the area was thoroughly

Marble Posts

Dealing with Scratched Marble Floor Tiles

24th March 2017 Reese Mackie 0 Comments cleaning services, floor restoration, hallway, kitchen, Lincolnshire, marble tiles, natural riven stone, re-sealing, Tile Cleaning, tile restoration, tiled floor, Woodhall spa

This Marble Tiled floor was installed in the conservatory of a house in Woodhall Spa who had asked if we could remove the scratches from their inherited marble tiles around the door area and where furniture had been dragged across the tile as shown in the photos. Interestingly our customer is a chief engineer on cruise ships all over the world and knew what this floor could look like if restored professionally. Burnishing Mable Tiles Other than the scratches the majority of the floor had been well maintained so the solution was to burnishing the marble back to its original condition using a set of diamond encrusted pads fitted to a slow speed machine and lubricated with a little water. The burnishing pads come in a set of four and applied to the floor with a little water one by one using a rotary machine running at slow speed. The process starts with the coarse pad which strips back the top layer and removes sealers and dirt from the surface of the stone. The pads then become finer and finer with the last pad being a final polish that takes the tile back to near it’s originally intended shine. You can see from the photographs that we actually managed to resurface the marble, remove the scratches and we also filled in some small holes and then allowed the floor to dry

Marble Posts

Polishing Marble Wall and Floor Tiles in Shropshire

27th February 2017 Reese Mackie 0 Comments albrighton, hallway, kitchen, marble tiles, shropshire, Tile Cleaning, tile sealing

For this job I travelled to the town of Albrighton, which is actually the most easterly settlement in the whole of Shropshire. My client had an issue with their Marble tiled floor which was installed in the kitchen and hallway. They had dropped and broke a bottle of vinegar in the kitchen, and the substance unfortunately came in contact with the tiles. Since Marble is highly sensitive to acid, the vinegar (an acetic acid) had basically etched the surface of the tiles make it impossible clean chemically. Although the tiles were a nice, expensive Marble, the person who had first installed them had done a poor job, leaving lippage of up to 5mm in some areas, which would make work trickier. Undeterred I could see it would be possible to restore the floor using a combination of burnishing for the tiles and cleaning with a high alkaline product for the grout lines. I demonstrated this to my client on one tile which went well and I was then given the go ahead to restore the entire floor. Cleaning and burnishing acid damaged Marble tiles My first task focused on cleaning the grout lines using a solution of Tile Doctor Pro-Clean worked in with a stiff grout brush. Pro-Clean is a high alkaline cleaner suitable for use on most types of natural stone floor. It helped to alleviate most of

Marble Posts

Putting the Shine Back on a Marble Vestibule Floor

17th February 2017 Reese Mackie 0 Comments congleton, east cheshire, hallway, marble tiles, Polishing, Tile Cleaning

A fantastic Marble tiled entrance hallway is the first thing you see when you open the door to this property in Congleton. Unfortunately, polished stone does need regular maintenance to keep its appearance, especially in high traffic areas such as this vestibule which had lost their shine, leaving them looking dull and unexceptional. Needless to say, the property owner was keen to get the floor restored to its former glory. That’s where I stepped in. Cleaning and Burnishing a Marbled Tiled Entrance Hall There was no evidence of old sealers present on the floor, so I started deep cleaning the tiles and grout lines using a solution of Tile Doctor Pro Clean mixed with clean water. A quick word on cleaning here, as an alkaline-based cleaner, Tile Doctor Pro-Clean is suitable for use on natural stone floors, including acid-sensitive stone such as Marble and Limestone. Many everyday household cleaners from the supermarket are acidic, which will erode the life of the sealer and a strong acid can etch the surface of sensitive stone, so make sure to source the correct cleaning product to avoid this problem. The cleaning solution was left to soak into the tiles for ten minutes before being worked in to give a thorough clean using a rotary machine fitted with a scrubbing pad. The